Does anyone know about corrosion problems of inconel alloys in CO/CO2 bearing gas (probable formation of nickel-tetra carbonyl)at temperature below 200°C.

I'm putting together a simulation of the energy budget for a car driving the NEDC and FTP-75 emission drive cycles. I need to incorporate the effect of warmup enrichment for gasoline and diesel powert

What are the pros and cons of Aluminum ratiators versus brass radiators?

I have burned out two compressor motors in a very short period of time and want to know if anyone has any ideas on what to check, I would greatly appreciate the help.

Have you had experience with the start-up of the liquid ring compressors/vacuum pumps? Is it a fairly operator intensive start-up procedure? Can it be started on auto? or does it need more TLC from an

Can anybody give me any advanced cause about the continuous damage of diaphragms(reinforced) of pneumatic control valve used for boiler feed water? (reverse acting,air quality good) .

I need to choose some valves for a neutralization plant involving Hcl Acid(30%, T°30C) pipes and NaOH (30%, T°45°C) pipes. The operating pressure is 6 Bars.

The octane thread got me thinking about pre-ignition vs. detonation. My truck, a 93 toyota with the 22-re engine with 192k miles on it, 'pings' under what I would consider a higher load condition (in